Jump to content
Popok

ZC Swift/Swift Sport Random Chit Chat Thread v2.0

Recommended Posts

1st Gear

Hi guys,

Starting the v2.0 of this thread, since the previous one is full.

↡ Advertisement

Share this post


Link to post
Share on other sites
1st Gear

to cmcrazy

 

not trying to offend anyone here... bbk is the most basic mod before anything else and yes its a little expensive for most (can buy 2nd hand if budget is tight)... but there is this saying... no $$$ no honey... no $$$ dont mod...

 

Cheers

 

the stock brakes are more than adequate. changing intake & exhaust doesnt have that much gains, that warrants a bbk.

I dont think bbk is a basic mod. Changing to better rotors & better pads is gd enough an upgrade for a swift sport.

 

Share this post


Link to post
Share on other sites
Clutched

to cmcrazy

 

not trying to offend anyone here... bbk is the most basic mod before anything else and yes its a little expensive for most (can buy 2nd hand if budget is tight)... but there is this saying... no $$$ no honey... no $$$ dont mod...

 

Cheers

 

the stock brakes are more than adequate. changing intake & exhaust doesnt have that much gains, that warrants a bbk.

I dont think bbk is a basic mod. Changing to better rotors & better pads is gd enough an upgrade for a swift sport.

haaa maybe been mixing around with many experience seniors... always asking me to watch this watch that dont over mod, etc. That being said, I am still appreciative over their advice.

 

Cheers

Share this post


Link to post
Share on other sites
1st Gear

Don't need change BBK la. The original stock brake for swift sport is already VERY good.

 

I did track with stock brake with upgraded rotor and brake pad.

Share this post


Link to post
Share on other sites
Clutched

to each his own...what you need may not be a must for others..

 

depend on what you go for ultimately..

 

no right or wrong one la..

Share this post


Link to post
Share on other sites
1st Gear

Get a final drive! :D Cheers to v2 of this thread!

 

wah bro final drive, gearbox mod..i dont dare do..ahhahaha

you on final drive?

 

Share this post


Link to post
Share on other sites

Clutched

bcrew set up is not bad....with aftermarket air-filters....

how about the reviews on the champion twin-filter?

Share this post


Link to post
Share on other sites
Neutral Newbie (edited)

Bro Popok

 

Some seniors did write report on swiftclub that to be better in low end, a 5.1 FD + some aftermarket clutch system, you will see differences for sure, but i remember him saiding this of cos will burn more fuel and very noisy, tradeoff for performance i guess. you can read swiftclub the whole day just to know more on all these performance stuffs. for me i only do cosmetic mods and very minor mods.

 

Bro Carbine-

 

I am on champion twin filter, what i can said that the engine can breathe easily and every service maintence just ask ur mechanics to dry blow it, can use for life, dont need to change air fliter anymore, go get one from bro eds and do throttle body cleaning(SGD 45) + this champion filter(100 SGD if i am not wrong) and u will feel your swift immediately back to the condition the first time you brought it. Cheers, if you want his no. i can give u.

Edited by Alvin1988

Share this post


Link to post
Share on other sites
1st Gear

Bro Popok

 

Some seniors did write report on swiftclub that to be better in low end, a 5.1 FD + some aftermarket clutch system, you will see differences for sure, but i remember him saiding this of cos will burn more fuel and very noisy, tradeoff for performance i guess. you can read swiftclub the whole day just to know more on all these performance stuffs. for me i only do cosmetic mods and very minor mods.

 

Bro Carbine-

 

I am on champion twin filter, what i can said that the engine can breathe easily and every service maintence just ask ur mechanics to dry blow it, can use for life, dont need to change air fliter anymore, go get one from bro eds and do throttle body cleaning(SGD 45) + this champion filter(100 SGD if i am not wrong) and u will feel your swift immediately back to the condition the first time you brought it. Cheers, if you want his no. i can give u.

 

hi bro,

yup there will be differences, you're basically shifting the powerband lower, therefore acceleration faster and the cost of topspeed..then again, how often would you need topspeed..after fd, can install 5th gear kit to lower the rpm at 5th gear.

Share this post


Link to post
Share on other sites
Neutral Newbie

Speaking of final drive.

any bros out there knows whether a zc11s, 1.3m swift can do a final drive?

or maybe changing to a sss gearbox?

 

its jus stuffs i read at forums, hearing gossips and such.

 

so wanna ask u guys for opinions and views.

 

thanks! [:)]

Share this post


Link to post
Share on other sites
Clutched

Anything is possible, it's the cost only that's concern. Conversion not cheap

Share this post


Link to post
Share on other sites
Neutral Newbie

Anything is possible, it's the cost only that's concern. Conversion not cheap

 

thanks bro.

 

thats what i heard too.

Share this post


Link to post
Share on other sites

anyone on rrp rom ecu?

For basic intake and exhaust mod, is there a difference with this ecu?

Share this post


Link to post
Share on other sites
Neutral Newbie

anyone on rrp rom ecu?

For basic intake and exhaust mod, is there a difference with this ecu?

 

yes there is a difference... i am running on this.. :wub:

Share this post


Link to post
Share on other sites

yes there is a difference... i am running on this.. :wub:

 

contemplating should i do it.. :blink:

what are your mods done with your rrp ecu?

Share this post


Link to post
Share on other sites

Hi guys,need your kind advise on some matters.recently i have been driving my zc11 and realise that upon coming to a complete stop my whole car will vibrate and the rpm will drop frm idling range of about 8k rpm to abt 6k rpm.was wondering what could be the cause of this issue and how to rectify.thanks for all kind advise from you guys.

 

Cheers~

 

Share this post


Link to post
Share on other sites

Hi guys,need your kind advise on some matters.recently i have been driving my zc11 and realise that upon coming to a complete stop my whole car will vibrate and the rpm will drop frm idling range of about 8k rpm to abt 6k rpm.was wondering what could be the cause of this issue and how to rectify.thanks for all kind advise from you guys.

 

Cheers~

 

i suppose is 0.8k drop to 0.6k... 8k rpm idling. then your redline shld be 20k. hahaha

 

throttle body dirty. go clean it

↡ Advertisement

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×