Ad information
Specifications:
- Ultra stable PWM (pulse width modulated) MOSFET power supply
- 2-ohm stable operation with an output power increase
- built-in crossover top control
ch ½ : variable hi-pass filter (40hz-1khz)
ch ¾ : variable hi-pass filter (40hz-1khz)
variable low-pass filter (40hz-250hz) - tri-mode capability for simultaneous hook-up of two stereo channels and subwoofer
- super bass control: 0-12db
- soft-start delay turn-on circuit
- automatic remote on/off switch
- power on and protect led indicators
- bult-in overload protection circuit
- bult-in over current protection circuit
- bult-in overheat protection circuit
- gold plated RCA input and transparent terminals
- line out RCA jack
There will be a warranty for 3 month if the installation was done at AutoImage.
Technical Specification Maximum output 800Watts 4 ohms maximum output @0.03% THD 800W RMS/1 ohm 4 ohms bridged mono output @0.02% THD 400W RMS/2 ohm 2 ohms WRMS output @0.1 THD 200W RMS/4 ohm Low pass filter 40Hz - 250Hz High pass filter 15Hz - 40Hz/Subsonic Frequency response 20 - 20KHz Signal to noise ratio 100dB Stereo separation >55dB Input sensitivity 100mV - 2.0V Input impedance 10 Kohms Operation voltage (negative ground) DC 14.4V Speaker impedance @ stereo driven 1ohm Fuse rating 25Ax3 Dimension (WxHxL) mm 320 x 50 x 264
- Car Audio Installation
- Car Audio Customisation
- Car Audio Tuning
- Car Security System Installation
- SoundProofing
Website: http://www.autoimage.com.sg/
Facebook: https://www.facebook.com/autoimage.sg/info
Ad information
Specifications:
- Ultra stable PWM (pulse width modulated) MOSFET power supply
- 2-ohm stable operation with an output power increase
- built-in crossover top control
ch ½ : variable hi-pass filter (40hz-1khz)
ch ¾ : variable hi-pass filter (40hz-1khz)
variable low-pass filter (40hz-250hz) - tri-mode capability for simultaneous hook-up of two stereo channels and subwoofer
- super bass control: 0-12db
- soft-start delay turn-on circuit
- automatic remote on/off switch
- power on and protect led indicators
- bult-in overload protection circuit
- bult-in over current protection circuit
- bult-in overheat protection circuit
- gold plated RCA input and transparent terminals
- line out RCA jack
There will be a warranty for 3 month if the installation was done at AutoImage.
Technical Specification Maximum output 800Watts 4 ohms maximum output @0.03% THD 800W RMS/1 ohm 4 ohms bridged mono output @0.02% THD 400W RMS/2 ohm 2 ohms WRMS output @0.1 THD 200W RMS/4 ohm Low pass filter 40Hz - 250Hz High pass filter 15Hz - 40Hz/Subsonic Frequency response 20 - 20KHz Signal to noise ratio 100dB Stereo separation >55dB Input sensitivity 100mV - 2.0V Input impedance 10 Kohms Operation voltage (negative ground) DC 14.4V Speaker impedance @ stereo driven 1ohm Fuse rating 25Ax3 Dimension (WxHxL) mm 320 x 50 x 264
Merchant information
More items from this seller
Similar Items
Email Enquiry
* indicates compulsory field.