Jump to content

1.3L Gen 2


Heartbreakid
 Share

Recommended Posts

I think Heartbreakid is driving a Wira.....r U asking him to change to the same model again?laugh.giflaugh.giflaugh.gif

↡ Advertisement
Link to post
Share on other sites

[laugh] What Caaa says is correct... I've been driving a Wira 1.3 for past 6 yrs, I need some fresh air man!! [laugh][laugh][laugh] Anyway, Proton's reliability doesn't impress me... As with any car nut, any new family car launch, I'll be there to take a peek at it... [laugh][laugh][laugh] Regardless I like it or not, for the sake of interest... [thumbsup][thumbsup][thumbsup]
Link to post
Share on other sites

Basically, what's wrong with your Wira's reliability?

 

Your must be the older model, not using the problematic Siemens ECU.

 

Shd be a reliable car.

 

What's wrong with it?

Link to post
Share on other sites

(edited)

Yep,mine WIRA is '96, using Mitsubishi ECU, Engine Wise everything is good till now, of course wore parts are replaced, just that when the car was new already got power windows problem, A/C blowing warm air due to a loose connection of the A/C fan... These are minor problems but good enough to dampen the spirit of a new car... The rest few yrs down the road, boot leakages... Latest batch WIRA all uses Siemens ECU, the intake manifold is different from my WIRA too...Heard is not good compared to Mit. ECU WIRA... Basically, what I was saying previous post "Not impressed with reliability" is, I'm referring to newer Protons like WAJA, Gen2 (in terms of fittings, and quality of parts)... No offence to These owners yah... [thumbsup][thumbsup][thumbsup]

Edited by Heartbreakid
Link to post
Share on other sites

Even a branded almost new made-in-Japan Toyota Corolla can have problems like -

 

1. Dash board rattling sound

2. All 4 external window rubber seal warped

3. Rear power window failed within 1st year

 

 

.... I think your budget Proton is pretty good already.

Link to post
Share on other sites

Emmm, I'm not sure man, becos I ones drove a '96 Corolla Tourer 1.6XLi (Estate) model before, it's a pretty neglected unit, more care (in terms of polishing, maintenance) has been given to the WIRA, but the corolla doesn't seem to give me much problems as compared to the WIRA when both cars are new, except the Corolla's high fuel consumption... I agree that cars nowadays build quality is a bit unreliable as compared to '90s... But because I've got 2 cars in comparison previously, I come to draw such conclusion to the WIRA... [thumbsup][thumbsup][thumbsup]

Link to post
Share on other sites

Neutral Newbie

oh you got the boot leakage problem too? I thought its my only my wira having this funny problem. After thunderstorm whenever i open the boot the water will just drip out. sometimes waited as long as 3 mins for it to stop dripping.

Link to post
Share on other sites

Oh yah, I didn't noticed the leakage until one fine I decided to pump air for the spare tyre, the level was abt 1 cm deep!! It took me sometime to pin-point the problem and realised it wasn't the boot seal problem, when the seal was removed, I found out that the there's gap between two welded parts, so I uses sillicon to seal up the gap and solves the problem!!

 

Oh man!! How I wished I could own a car but too bad, I'm only an over-age undergrad [laugh][laugh][laugh] and financially tight!! [shakehead][shakehead][shakehead]

↡ Advertisement
Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...