Increase Throttlebody size

[Turtlekar]

hello bro....mine only at most warrant officer...still havent commission to SiR yet leh....so have to go shopping around for stuff lah...btw, how's your rim hunting??? found your best rim???

[Michel]

if u notice, there's a 'Url' button above the message board. So, if u wanna make a hyperlink, just highlight your so-called URL or web address, then click on it and Voila!!! It's hyperlinked...

 

Cheers

[Saaber]

Sure shiok one...

[Hkfung]

okkie, thanks man

[Hitman]

Not yet still lookin ..... I not in a hurry as my Michelins stil got 70% thread. Rims I very particular one ..... better not be a salesman attending to me when I am looking for rims or you sure

[Turtlekar]

u really are the man can slowly go and source for your favourite rim

[Silversti]

Sure it will help with additional fuel regulator, But the hassle to bore it out is a risk if not done properly as your rpm will go up and down. If possible get a similiar throttle body from the higher CC car will be a better bet. Go the used part importer to see if have any luck. Another thing is the final diameter must be similiar to that of the manifold or else it will be square one.

 

[Colinq]

Personally have had trottle jammed open before, scary thought.

 

have a friend who's Cyclone slipped out of place and headed for the throttle butterfly

 

fortunately for him, he didn't do any sprints before his dyno - during the dyno, the throttle stuck on open!!

 

needed an engine flush after that as there were metal flakes at the throttle body mouth due to physical contact between the butterfly and the cyclone