Where to adjust Coilover height? any west side WS at decent price?

[Boyboy]

As above. prefer west side. Reputable shops in JB also can

 

i don't need to do alignment. Just need to adjust height, then let the car "settle in" before going in to my usual JB tyre shop for alignment. intend to lower my BC coils to lowest (or near lowest) setting

 

i got these from FK less than a yr ago btw, already adjusted height once after installation so not sure if he will do it again for me FOC. besides, it's in the east side, same distance as JB is for me

[Marcng]

i think jb only does it abt 10-15rm per side...

and if u go lowest(no gap btw rubber and fender)u also need to do fender roll if not when u do hard corning the rubber will rub against ur fender........

[Sash7]

why dun call FK for quote first? maybe cheaper than outside?

[Boyboy]

what is fender roll ah?

 

so did u have to do it for ur ride? maybe i won't lower all the way.. but just to the point where it wun rub fender.. see what the WS says.

 

will drop by FK later if timing is right. cos i going to genconcept to remove my SGcarmart stickers

[Turbonetics]

its advisable to go back to the same workshop,most probably they will charge you.

and do remember to install a camber kit if you have not gotten one yet.

[Turbonetics]

1-11/2 inch between fender and tyre is quite ideal.

[Marcng]

yes i did fender roll and also camber nut.

[Boyboy]

i just lowered some more at FK. also change header

 

but low end seems to have suffered a bit. high end not sure, traffic very bad, no chance to test

 

maybe need to go back to harmony motors to do "touch up" tuning