Search the Community
Showing results for tags 'Bonet'.
Found 3 results
-
hi , apart from cutting the bonet or to change to vented ones... to raise the rear part of the bonet to vent heat, qns is how much to be raise. hear before from workshop. raise abt 12~15mm the gap. is it good? wat is recommended? adv : heat wont trap under bonet , lower temp. disadv : those go outside car wash, water may jet into engine bay. ------------------------------------------------------------------------------------------ i tot of raising the rear to vent heat. at the same time. put rubber sponge to block from the passenger side to the after-the-fusebox to prevent heavy rain from splashing at the batt and fuse box. <-- thats where the fuse box and batt are. well the driver side of the car is not so much of electrical though. and while moving is not so much of a issue to water enter from gap. only worry if go car wash... inside spray like swimming pool ahhaha.
-
Hiya, anyone know the estimated cost of a camry 07 bonet and preferred stocklist to go to? Cheers
-
Seems like a good deal... RM30 cheaper than what I paid.. But too bad, seller is in KL, not JB. Brought mine for RM99 at Brothers. **************************************************** Fits (Plug n Play) Wira, Satria, Putra, All wira design front cars NEW 3 months warranty RM68 NEGO NEGO Just unscrew the are screw and fit this in, instruction on the box. you can DIY but 2 person do the fitting safer. Then you will have a nice cool looking when u open your bonet. Kum 016-5040890 Location KL No design for other cars yet. ****************************************************
