Search the Community
Showing results for tags 'touchup'.
Found 8 results
-
Hi bros,,, Anyone purchased for custom mixed spray can paint (to match your car colour code) Locally? a friend of mine from US told me that it is commonly done and widely available there, but in SG totally no news. Or DIYers that spray paint, touchup/repair paint yourself, what method do you guys use to DIY paint your car ? Maybe invest in airbrush and buy small amts of paint from Paint shop? Want to touch up & spray up some parts of my car, but touchup paints not doing too well cuz the area is about 3"x3" Thanks in advance !!!!
-
anyone knows where can i get touchup paint for the above? thanks!
-
Hi all, where is a good place to touch up/repair curb rash on rims? Prices must be reasonable of course.
-
Hi guys, just want to check if anyone knows where to get clearcoat touchup pen?
-
Hi all, This LGT came without much defects except some light swirls on the 3 horizontal panels. There were also the usual wash lines on the sides which were easily removed. Compared to the white colt done the previous week, this was a breeze except for the soft subaru paint and the larger dimensions. Oh, those Enkei rims, though not as bad as some 20 over spoke conti rims, took a little longer to wash The process: 1) Wash n clay 2) PC with IP and PO106FF mixture on Orange LC pads 3) Rinse 4) PC with CG Wet Mirror Finish and Grey LC pads 5) PC with Blackfire's Wet Diamond and Blue LC final finishing pads x 2 layers This is a new combination to me as I went with WMF and Jetseal or M-Seal for a bright sparkling look and Ez creme with Wet diamond or Factory sealant for that dark glossy wet finish. The results? as follows.... Bonnet: Roof: Sides:
-
Hi Bros, Was wondering anyone got lobang or recommendation for Excess paint remover.. this is usually used for paint touch-up to clean off excess paint after you apply the touch-up layer, without damaging your existing paintwork; something like this Link: http://www.touchup123.com/pc-55-3-glob-doctor.aspx -
I just got a tiny chip off on my bonnet courtesy from a small stone at PIE . Yesterday I just got time to touch up the exposed metal with my touchup paint, however I did not do a good job, some of the touchup over lap to the existing paint. Is there anyway to remove the overlapped paint? Now a bit of regret, should have just cover the exposed part with soft99 Fusso 12 month coat, now the bonnet look like it got a mole. Another question is how long must I wait for the paint to cure before I cover it up with the fusso coat?
-
They will fill up and smoothen the scratches, and spray paint it to your desire color. Anyone got any lobang?
